What is a forklift safety at work requirements?

1. The door frame may not have the phenomenon of deformation and seam sealing off, rolling to the inside and outside the door frame clearance should be adjusted reasonably, no larger than 1.5mm, the wheel rotation should be flexible wheel and shaft should be no cracks, defects. The amount of wear of the wheel groove shall not be greater than 10% of original size.

2. Two lifting chain degree of tension should be uniform, not distorted, the end of the solid connection, the chain pitch shall not exceed 4% of its original length, it should replace the chain. Sprocket rotation should be flexible.

3. Fork frame shall not be severely deformed, weld sealing off phenomenon. The surface of the fork shall not crack, seam open welding phenomenon. Fork root angle not greater than 93 °, the thickness of not less than 90% of original size. Left and right fork tip height difference should not exceed 3% of the level of fork length. The positioning of the fork should be reliable, forks tied to the bearing surface, the positioning surface may not have obvious defects, and fork with the gap of the fork should not be too large, and move smoothly.

4. The lifting cylinder and door frame connected parts should be solid, tilt cylinders and the door frame, the frame hinge should be reliable, flexible, with the gap is not too large. The fuel tank should be well sealed, no cracks, smooth. Rated load, 10min gantries from Shen amount not greater than 20mm, the inclination is not greater than 0.5 °. Lifting speed at full load should not be less than half of the standard value.

5. Overhead guard, backrest must be complete and valid.

6. Fork up and down is strictly prohibited to stand does not allow pork on a skewer with single goods take a load of goods.

7. Forklift driver must be equipped with a forklift driver's license, avoid a forklift multiple drivers.